WisyCom MTK952 User Manual download pdf (Page 16)

MPR30-IEM User Manual

Rev. 06



Sync

The SYNC function is useful to tune a transmitter on the same

frequency of the receiver via the IR interface. Before starting the

sync function tune the receiver on desired channel, manually or

using the SCAN utility. After this, enable the IR interface on the

transmitter. Now press UP&EXIT buttons together or enter in the

Sync menu to start the SYNC function. Keep the IR window of the

transmitter in front of the IR window of the receiver and, as soon as the connection is done, the

receiver will send to the transmitter all the information needed.

If the operation is not possible, (i.e. the frequency range of the transmitter is not compatible with

the frequency of the receiver), the display will show an error message.

If the transmitter         function is completed it will

show the same name of the synchronized receiver.

Advanced

The Advanced menu allows to manage advanced settings.

PARAMETER

SETTING

MEANING

Lock volume

Yes / No



display an open lock is displayed on the Status

Display. After Display -Low timeout

becomes closed and the lock volume is enabled.

To enable the volume setting it is necessary turn

the volume knob below the previous setting or

 

Pilot Squelch

Yes / No

When the Pilot tone is enabled, the audio output is

muted unless the correct carrier is detected

(19kHz).

When the Pilot tone is disable, the audio output is

muted if RF level < Squelch level.

For the presence/absence of audio output, check

the upper symbol in the status display.

Clone *

Add

00÷23

To add a clone

Load

Default/00÷23

To load a clone *

Delete

00÷23

To delete a clone *

Delete all

To delete all the clones *

* A clone is a partial configuration of the MPR30-IEM which can be copied from a receiver to another

using the IRDA interface. It consists of the same parameters of pre-set configuration for less than

display, quick menu and headphones parameters (see the Operating menu for more details).

From firmware version v1.3 the MPR30-IEM is able to manage up to 24 clones (from 00 to 23). The

menus of the clone management allow to add/load and delete a clone.

* It appears if exist at least a1 clone

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Comments to this Manuals

No comments

WisyCom MTK952 User Manual Page 16

Comments to this Manuals

Related products and manuals for Unknown WisyCom MTK952