WisyCom MTK952 User Manual download pdf (Page 13)

MPR30-IEM User Manual

Rev. 06



“Scan now” menu

The following table lists the three types of scans that can be performed

Channel

Once started a Channel scan operation the receiver asks for

group to be used*. Press and hold the SEL button to select the

group to scan.

Then it prompts to turn off all transmitters.

So press SEL to start the scan!

After few seconds, scan results are displayed sorted by level,

making easier to pick up the best one.

The dotted line in the graph indicate the squelch threshold.

Under the graph are reported the following parameters:

- Ch: Channel

- Rank: Ranking position

- Freq: Frequency

- Lev: RF level

Pushing simultaneously UP and DOWN button, the results can

be also displayed on a chart in ascending order according to

the number of the channel.

After the selection of the desired channel, a screen appears

with the selected frequency, channel and group and it is

possible to Set or Synchronize the receiver with the

transmitter. We recommend setting the frequency and then

synchronize it with the transmitter.

Groups

If the scan is done on Groups, you can choose a maximum of

10 groups from among the 40 groups shown in the table

(Press the SEL button to select and press it again to deselect).

In the upper left shows the number of the selected group and

the number of selected groups, while in the upper right corner

there is the item "START" to start the scan.

To select START, go to the box 39 and press the "UP" button or

go to the box 0 and press the "DOWN" button, so press SEL to

run the scansion.

Then it prompts to turn off all transmitters.

So press SEL to start the scan!

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

No comments

WisyCom MTK952 User Manual Page 13