WisyCom MTK952 User Manual download pdf (Page 23)

MPR30-IEM User Manual

Rev. 06



HOW TO USE MPR30 RX MANAGER

Wisycom MPR30 RX Manager can be used to load or save the channels memory and upgrade

the firmware.

Instruction to connect MPR30 using UPK300 / UPK300E:

1. Connect to the PC the infrared programming interface (UPK300 or UPK300E) using a

USB cable (NOTE: it is not possible to use IR interface of MRK950 or MRK960)

2. Check if the version of ENG RX Manager installed in your PC is the latest version. If

not, uninstall the ENG RX Manager actives in your PC and install the new version

3. Run ENG RX Manager

4. Power up the receiver MPR30 and enable the IRDA interface:

a. push button,

b. push button until that Infrared submenu appears on the display

(Headphones>Edit RX>Display>Infrared)

c. push again button 

5. Put in contact MPR30 and UPK300/UPK300E

6. Push Disconnected button. On the Device connection windows select UPK port and

verify that upk300 is

selected on the

Silabs USB devices

panel. If upk300

device is not

showed, push

Refresh button

and/or try to

disconnect and

reconnect the USB

cable connected to

the UPK300. Then

click OK.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

No comments

WisyCom MTK952 User Manual Page 23