WisyCom MTK952 User Manual download pdf (Page 11)

MPR30-IEM User Manual

Rev. 06



From Status Display push SEL and EXIT together to enter on the

Main menu

Use UP/DOWN to navigate on all available menus

Push SEL to select a menu item

Use UP/DOWN to move on the different parameters of the menu

Push SEL to modify the parameter menu

Use UP/DOWN to change the parameter value

Keep push SEL to save changing

Push EXIT to return on the Main Menu

Push EXIT to return on the Status display

Audio settings

The Audio settings menu allows to configure the audio output.

PARAMETER

SETTING

MEANING

Out mode

Stereo

The left and right signals are available as usual. The Balance

setting serves to adjust the balance between the left and

right stereo signal.

Mono

The left-right signals are mixed and are available as a mono

signal in both headphone channels. It is not possible to

adjust the level of the 2 channels as in Out mode Mix.

Mix

The left-right signals are mixed and are available as a mono

signal in both headphone channels.

The Mix mode setting serves to adjust the relative levels of

the two separate channels in the mixer mono signal.

Equalizer

Low and High

frequencies

-12dB/+12dB

1dB steps

This menu allows to of adjusting the gain of low and high

frequency components (bass and treble) within the audio

signal.

1. Push UP/DOWN button to increase/decrease the

gain of the Low frequencies (50Hz)

2. Push SEL button to shift on High frequencies,

3. Push UP/DOWN button to increase/decrease the

gain of the High frequencies (10kHz)

4. Keep push SEL button to SAVE

Vol. boost

-12/-6/0/3/6/9/12dB

This menu allows to increase or decrease the volume of the

output headphones, selectable from -12 dB to 12 dB. Set the

appropriate volume boost and then adjust the volume with

the control knob.

Output load



Set the Output load according to the impendence of the

headphones connected

Pwr limit

OFF (only using lithium

battery) / 100mW /

50mW / 30mW

This menu allows to limit the power output. If set to

OFF(only lithium battery), there is no power limit control. If

set to OFF using alkaline or NiMH batteries, the receiver set

automatically the max value permitted (100mW)

NOTE: When the volume knob is rotated, appears a screen with a

volume bar and the values of Pwr limit, Outpul load and Vol. boost

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Comments to this Manuals

No comments

WisyCom MTK952 User Manual Page 11

Comments to this Manuals

Related products and manuals for Unknown WisyCom MTK952